1. Product Introduction
The RY-LC-NB/SIR lightning monitoring device is another high-tech product that our company has been committed to for many years in the field of "online monitoring of lightning protection". This product has the functions of online monitoring of lightning current peak value, lightning current polarity, T1 and T2 time of lightning waveform, SPD lightning strike frequency, real-time temperature and humidity, etc. The product adopts a solar powered waterproof design, which has the characteristics of small size and easy installation. The device itself is based on NB-IOT communication and is also equipped with RS485 interface, which can be combined with other intelligent IoT devices to achieve richer remote online monitoring functions.
2. Product Appearance and Dimensional Drawing
Figure 2-1 Product Appearance Dimensional Diagram
3. Basic Function Introduction
4. Installation and usage instructions
Figure 5-1 Equipment Installation Diagram
Fix the lightning monitoring device RY-LC-NB/SIR near the down conductor or lightning arrester grounding wire that needs to detect lightning strikes, install it in a waterproof box that can provide 12Vdc DC power, and then connect the equipment according to the diagram before powering it on.
5. Wiring method for power supply of lightning monitoring device
① Connect the+port of the lightning monitoring device to the+port of the 12Vdc power supply
② Connect the port of the lightning monitoring device to the port of the 12Vdc power supply
6. Wiring method for lightning current peak collection coil
① Connect the LS terminal of the lightning current peak collection coil to the LS port (Port 3) of the lightning monitoring device;
② Connect the GND terminal of the lightning current peak collection coil to the LS port (port 4) of the lightning monitoring device;
③ Pass the grounding wire through the center hole of the lightning current peak collection coil.
*Attention: The lightning current peak collection coil needs to distinguish the direction of current.
After power supply, the collected data and related configuration information can be viewed on the OLED display screen of the lightning monitoring device through the page turning induction key. The device can also be debugged through RS485 and connected to a computer to view the collected data using Modbus tool software. Alternatively, the latest status of the device and various collected data can be viewed by logging into the management platform of the demand side IoT through the account assigned by our company. The communication of RS485 interface is implemented according to the definition of the "RY-LC-NB/SIR Lightning Monitoring Device Communication Protocol" document.
Revision history
